- September 13, 2011
- By Texas Express
- In Cooling System
- 1337
- 0
Our cars have to operate in a wide range of Texas temperatures and our engine coolant must be able to perform ‘no matter what’. Think for a moment about the environment where the coolant works. Very hot, high pressure, corrosive…
And all the while, it has to protect the components of the cooling system from corrosion. These components are made from steel and aluminum, plastics and rubber. The coolant has to be formulated to protect against corrosion for all of these different materials. That’s why different manufacturers recommend different types of anti-freeze for our Texas vehicles.
There are several different ‘families’ of anti-freeze available to us here in Texas. Your owners’ manual will tell you what kind you should use. Of course, Texas Express Lube & Auto will know what to put in your car.
It’s important to stay on top of this because coolant system failure is the most common mechanical problem people have. Regular service at Texas Express Lube & Auto needs to be done to avoid failures and also to keep your warranty in place.
While the specifics of the service required may vary from vehicle to vehicle, your service consultant at Texas Express Lube & Auto will know what to do. You’ll be advised to replace the coolant at specified intervals.
Some manufacturers may recommend periodic coolant system flushes. A flush adds a cleaning step to the fluid replacement process. Again, check to see what your service consultant recommends.
Someday, you may have to deal with an overheating problem, so you need to know what to do if your coolant temperature warning light comes on or your temperature gauge is in the hot zone.
Now, overheating can be very expensive. You can literally melt down your engine and have to replace the whole thing. So take the warning signs seriously and take immediate steps.
First turn off the air conditioner. This will lower engine temperature right away. Next turn your heater to maximum heat and run the fan at high speed. You might need to roll down the windows, but this will take a lot of heat off the engine.
Pull over as soon as you can safely do so, especially if you are stuck in slow-moving traffic, and shut the car off. It may take as much as 45 minutes for the engine to cool to the point that it’s safe to operate the car again.
If you need to add water or antifreeze, be sure to wait until the car cools down. Opening the radiator cap or even the overflow bottle when the coolant is hot and under pressure may result in serious burns.
So after the engine has cooled for 45 minutes or so, look to see if the coolant is low in the overflow tank. If so, you can cover the overflow tank cap with a large cloth and open the lid. Then start the engine and pour in some water or antifreeze. Pouring it in when the car is running will circulate the new, cool fluid with the warmer fluid in the engine and avoid engine damage.
Of course, overheating is a serious problem and you need to get it fixed right away. Texas Express Lube & Auto can make sure the coolant is right before you drive home.
Those spring and winter inspections really come in handy when they head off a cooling system problem. And don’t forget that severe service driving conditions, like towing or hot, dusty driving around Luling or Kerrville, Texas, mean that you’ll need to service your coolant more frequently.
At AutoNetTV, we suggest that you have Texas Express Lube & Auto inspect your coolant system to find small problems before they become big, and to change belts and hoses before they fail. After all, we don’t want you to lose your cool out there.